Uncovering bargains from Australia’s favourite retailers!
Uncovering bargains from Australia’s favourite retailers!
found at DigiDirect
The Edelkrone Monitor/EVF Holder permits fast and easy monitor or EVF adjustments without the need to loosen and tighten any bolts to tilt up or down. Thanks to the constant friction system inside the monitor holder, you can just push the monitor up or down, and it stays where you put it. Monitors up to 9 can be attached.
The Monitor/EVF Holder fits onto standard shoe mounts, allow you to attach it directly to your DSLR or camera, an edelkrone Modula rig, or any other rig with a standard shoe mount. The Monitor/EVF angle can be adjusted with one hand and allows you to switch instantly from shoulder setups to low handheld setups. In addition, its symmetrical design allows it to be flipped for mounting on either side of the camera. The length of the unit also accommodates camera operators who prefer to use their left eye when using EVFs.
Monitors and viewfinder attach to the Monitor/EVF Holder via a 1/4-20 screw, and you can adjust the resistance/friction level to accommodate monitors and EVFs of different weights. A second 1/4-20 screw underneath the Monitor/EVF Holder allows you to attach additional accessories.
The most frequently used monitor/EVF adjustments are tilt-up and tilt-down.
You no longer need to loosen or tighten any screws.
You can attach the Monitor/EVF holder to hot/cold shoe mounts or to ports with 1/4-20 screws.
You may want to place your monitor/EVF on the side or the top, in the front or the back of your camera. Thanks to the flexible design of the Monitor/EVF Holder, all of these options are possible and really easy to set up.
Monitor/EVF holder has an extra shoe mount on its side to accommodate an LED light, or a microphone, or a wireless receiver, or any other accessory you may have that uses a shoe mount connection. You name it! There is also a 1/4-20 port under the monitor plate to attach even more accessories on the Monitor/EVF Holder.
You will always have room to attach the cables without awkward sharp bends around their ports.
You may attach monitors of up to 9 and there is still some room left around! The Monitor/EVF Holder is fully compatible with most EVF's.
You can adjust the counterweight level of the Monitor/EVF Holder and work with most monitors or EVFs regardless of their weight.
